Home » Automatic SPC » spc-lab
Designed for the shopfloor to be used beside the production machinery
Dimac mobile units for SPC control are rapid and accurate. They allow the measurements of simple and complex geometries on the shopfloor without the skills and needs of a metrology room. With one click, all the measurements are ready to be shared with the company ERP system. Rapid inspection plan set-up, rapid inspection plan saving and retrieving.
AVAILABLE CONTROLS
Complete range of measuring functions for diameters, lengths, angles, radii, and threads of all types. INSTANT VIEW of the measurement trend with the calculation of statistical parameters and storage of batch data.
Suitable for parts with cylindrical geometry made by cold forging or turning
Small parts, screws, bolts, pins, dowels, tie rods, fittings, bushings, inserts, joints, studs, and special cylindrical symmetry parts in any material.
SPC-360 system works with control plan recipes prepared by the quality control department for a family of parts produced in the company. SPC-360 system interfaces with the company ERP-System to verify the correct alignment of the control plan version and enable the cycle starting.
The operator chose the part number from the scheduling list of the production machines to reduce the risk of mistakes.
After the measures, a validation process is designed to prevent corruption in the main data storage. Operators can address anomalies by choosing to accept the automatic measurement value, repeat the measurement, or correct it manually. SPC-360 tracks any modifications in the data and identifies the responsible operator. The validated acquired data is promptly transferred to the company’s ERP system, eventually with all the corresponding pictures or a selection of them.
MSA1 and MSA3 tests were performed with success, with a sigma < 0,001 mm on measures taken in backlighting and, a sigma close to 0,002 on measures taken with direct lighting.
FAST
Up to 100 measures
in less than 1 second
DATA ON ERP
Real-time sharing
with ERP system
ACCURATE
Micrometric resolution
and repeatability
up to 5 μm
RELIABLE
Human error free
Non-contact measurements
No part clamping
EASY TO USE
Automatic
User friendly
Rapid setup
RUGGED
Designed for shopfloor
environment
All Dimac machines are designed for an innovative approach to quality factory organization that integrates SPC controls, quality 100% controls, and the company IT system to drive metal component industries towards a ZERO-DEFECT FUTURE.
All Dimac machines are designed for an innovative approach to quality factory organization that integrates SPC controls, quality 100% controls, and the company IT system to drive metal component industries towards a ZERO-DEFECT FUTURE.